AS/NZS 4130:2003
Polyethylene (PE) pipes for pressure applications
WARNING: SUPERSEDED Standard. This document has been replaced by AS/NZS 4130:2009
$74.94 NZD (ex GST)Retail
$59.95 NZD(ex GST)Members
$67.45 NZD (ex GST)Retail
$53.96 NZD(ex GST)Members
Specifies requirements for polyethylene pipes for the conveyance of fluids under pressure. Such fluids include, but are not restricted to, water, wastewater, slurries, compressed air, and fuel gas.
[hide]Publishing Information:
Status: SUPERSEDED
Published: 18/03/2003
Pages: 23
Comments:
Superseded by AS/NZS 4130:2009
ICS Codes:
23.020.30 Pressure vessels, gas cylinders23.040.20 Plastics pipesReferences:
[show]Standards NZ References:
- 1462.1:2001(AS/NZS)
- 1462.26:2003(AS/NZS)
- 1462.28:2003(AS/NZS)
- 1462.4:2002(AS/NZS)
- 1462.6:1998(AS/NZS)
- 18.28:1991(SANZ/SAA HB)
- 2566.1:1998(AS/NZS)
- 3500.0:2003(AS/NZS)
- 4020:2002(AS/NZS)
- 4131:2003(AS/NZS)
[show]Non Standards NZ References:
- AS 1199 Sampling procedures and tables for inspection by attributes
- AS 1462.24 Methods of test for plastics pipes and fittings Part 24: Determination of resistance to crack propagation?Test methods for slow crack growth in notched pipes (notch test)
- AS 1745.2 Outdoor weathering of plastics in the Australian environment Part 2: Guide for design purposes
- ISO 11357-6 Plastics?Differential scanning calorimetry (DSC) Part 6: Determination of oxidation induction time
- ISO 12162 Thermoplastics materials for pipes and fittings for pressure applications? classification and designation?Overall service (design) coefficient
- ISO 13479 Polyolefin pipes for the conveyance of fluids?Determination of resistance to crack propagation?Test method for slow crack growth on notched pipes (notch test)
- ISO 13954 Plastics pipes and fittings?Peel decohesion test for polyethylene (PE) electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm
- ISO 2505-1 Thermoplastic pipes?Longitudinal reversion Part 1: Determination methods
- ISO 2505-2 Thermoplastic pipes?Longitudinal reversion Part 2: Determination parameters
- ISO 2859-1 Sampling procedures for inspection by attributes Part 1: Sampling plans indexed by acceptable quality level (AQL) for lot-bylot inspection
- ISO 3 Preferred numbers?Series of preferred numbers
- ISO 3951 Sampling procedures and charts for inspection by variables for percent nonconforming
- ISO 4437 Buried polyethylene (PE) pipes for the supply of gaseous fuels - Metric series?Specifications
- ISO 497 Guide to the choice of preferred numbers and of series containing more rounded values of preferred numbers
- ISO 9080 Plastics piping and ducting systems?Determination of the long term hydrostatic strength of thermoplastics materials in pipe form by extrapolation